803-796-6326

Sure there are a lot of unhappy testimonies that property owners have pertaining to water heater maintenance of “stumbling out of bed to the freezing shower.” Well, we are not about to focus on how regrettable of a circumstance that may be. Likewise, we will assume that one understands the basic notion of ensuring ones water heater is serviced systematically in an effort to receive the best out of its expected life, and to make sure an emergency Water Heater Repair in Columbia SC is not needed. This will help one spend less on utility costs as well. All that makes sense we know. While not needed a lot of maintenance, hot water heaters will need some. We are astounded, even though not shocked, by the quantity of customers we come across who haven’t executed any specific servicing to their water heater), listed below are the responsibilities people must be informed about regarding maintenance.

The Probable Duration a Columbia Water Heater Should LastHot Water Heater Repair in Columbia SC

8 to 10 years is the normal amount of time a standard gas water heater will last. There are numerous variables that will have an impact on the all around lifetime needless to say, however this is a good average. Most likely the greatest factor which will impact the longevity of it is actually mineral deposits. The steps reviewed below are presented in hopes of assisting to lower the accumulation of mineral deposits in the storage tank of a water heater.

Ways to Reduce a Columbia Water Heater Repair

Homeowners, even those which never feel extremely handy, can perform a lot of water heater preservation independently. Although in most cases, a water heater will function harmless, remember that they actually do run from an electrical source and/or gas. Thus suitable safety measures should be put into practice by Columbia property owners. Remember to apply these guidelines as an informative tutorial, for we would much rather explain all these together with you in person.

First, the hot water heater’s electrical power needs to be turned off ahead of engaging in any routine maintenance. Ones breaker box hopefully has a switch labeled that indicates which breaker is the heater’s. House owners who possess a gas water heater, rotate the gas cutoff counterclockwise in order to switch off the gas.

Anode rods, or referred to as sacrificial anode rods, are the section of the heater that aids with controlling rusting inside the water tank. The majority of are constructed from aluminum while others are made out of magnesium around a steel wire. In time the external covering of the rods will erode and they really should be replaced when the steel wire is obvious. They ordinarily last around 5 years, though that can be reduced if ones water is soft. In the long term, it is better and less expensive to have the anode rods replaced, in order to have a long life from the water heater storage tank. The rods should be examined on a yearly basis.

Have a look at the following video which illustrates the procedure of changing the anode rods:

The next water heater component this article will look at are the dip tubes. Not every water heaters possess them however. They should be examined every 6 months for corrosion. To evaluate it, remove it and compare its length to the height of the water heater. It should be about 6″ to 8″ shorter compared with the tank. It will need replacing whenever it’s shorter than that, or displays signs of breakage or crumbling.

Forms of water heater flushes. Once more, mineral deposits are the biggest cause of water heater breakdowns. How fast sediment establishes inside the storage tank is determined by the quality of ones water. In time, this sediment can harden, triggering weird sounds from the storage tank, reduce the effectiveness of the water heater, and potentially clog the drain valve. If possible, every 6 months, but at least once a year, empty 1 or 2 gallons of water from the drain valve at the bottom of the hot water heater in a pail or through a garden hose in a bucket outdoors. Look to check out what amount of sediment is within the bucket when the water settles. If it seems to be fairly clear, that great! If these small flushes are done two times per year, one will possibly not have to complete a big flush as often. If the water appears really cloudy, a full flush needs to be done. It is also a good occasion to ensure the bottom drain valve of the storage tank is working good and not leaking. These are ordinarily made of plastic and as time passes when they aren’t opened up, they are going to get stuck or not close securely, which is why it really is advisable to open and close them in the course of the small flush test.

The flushing process can assist with removing hot water smells that can also occur too.

The advantages for flushing a water heater are illustrated in the following video:

For everyone that has vacation homes or seasonal homes, one ought to drain the storage tank of all its water to help in order to avoid any flooding throughout the seasons the house is not lived in. Needless to say, ensure to refill it while the dwelling is to be lived in once more.

Inspecting water pipes. Look to be certain all water pipes do not have leaks or are defective at all. This should be simple and easy to see when there are any leaks coming from any part of the water plumbing or storage tank for there will be water below and/or near the unit. Leaking water can result in water damage to elements of ones house, so be sure that all seems dry, especially if the heater is located on the inside of the house and not in a garage.

T&P valve examination. Yearly, the T&P valve, or temperature and pressure relief valve, will need to be examined. The T&P valve’s purpose is to preserve the water heater storage tank from too much pressure, and blowing up. The owners manual must be looked over to guarantee the proper ways are implemented but listed here are the standard techniques. A little water may come out of the valve and will probably be really hot so be careful. Raise the lever and let go of it. Have a container prepared to catch any unwanted water which can come out. Additionally, the noise of pressure being released will be observed. The lever ought to snap back in place. If it fails to try it once again. In cases where after a few tries it will not go back again into place, a replacement will likely be needed. The valve could drip some water afterwards for a little while. If it does not quit dripping after a few hours let us know.

Throughout the years, much debate has happened on precisely what the best temperature ought to be for a water heater. Manufacturers commonly pre-programmed heaters to a setting of 140 degrees, which is actually warmer than the majority of people will ever have to have. 120 degrees is the standard temperature and a number of people actually go as far as 100 degrees. We are writing more about this, but we advise having the temperature to approximately 120 degrees.

Steps For Gas Water Heaters

Every 3 months is a good time to looked over the gas venting system. All the fittings ought to be checked to be sure they are tight, look for blockage, and search for damage to the vent piping, and also ensuring these are totally free of rust and deterioration .. Fumes are vented to the outside of the household with gas fired heaters. If these gasses make their way inside of the dwelling it can be poisonous and a fire danger. Ensure everything flammable or corrosive is far from the exhaust ventilation to help alleviate problems with fires. Any loose, damaged, or corroded portions of vent pipes should be updated.

Check the pilot light to conduct a visual test of the way it is working. The task of the pilot light will be to ignite the gas burner that heats water for the home. For ones water heater to function at top performance, it is very important for the pilot light to be clean. The flame color should really be blue with natural gas heaters. For propane heaters, the flame ought to be blue/green with only a small amount of yellow at the tip. A weak flame, a yellow flame, or a flame which has a split flame at the top signifies that a modification is necessary.

Guidelines For Electric Water Heaters

Applying insulation wraps or blankets covering the storage tank can certainly help retain a continuous temperature inside the storage tank without needing as much power. Moreover, by the heater not needing to run as often will increase the life span of the heating element since it will not be used so much. Every so often, check the insulation cover to ensure it is still attached and hasn’t fallen or moved on the water storage tank.

Routine examination of the heating element is very important and definitely will help lessen the need for an unexpected emergency repair. We aren’t going to get into the particulars for a complete inspection in this article, however one will need a voltage/OHM meter to be certain there exists a closed electrical circuit. Heating elements do need updating occasionally.

The area around a water heater needs to remain clean of dirt. Especially if the water heater is placed in the garage, be certain to give the space a sweeping on a regular basis. Ones heater will function a great deal better and be not as likely to call for a Columbia Hot Water Heater Repair if it stays clean.

Replace Old Water Heaters With Energy Efficient Ones

At present, nearly all water heaters manufactured possess a nice amount of energy efficiency. In April 2015, stronger efficiency codes were started in the U.S. for water heaters. Certainly, the better the heater, the longer the life one is certain to get from the unit with the ideal servicing over the years. Don’t be reluctant to call Water Heater Repair Columbia SC to discuss water heater maintenance or maybe to answer any problems on picking out the most proper replacement water heater for ones household or office. Brand, model, and size need to all be considered in the selection process and not simply use the “bigger the better” slogan. Regarding storage tank water heaters, it is a waste of energy to have lots of surplus water being always heated up to a hot temperature if it is not getting used.